Removing Memory Modules - Compaq AlphaServer 1000A Owner's Manual

Installing and Removing Components

Removing Memory Modules

_________________________Caution____________________________
Static electricity can damage electronic components. Use an antistatic wriststrap
when you handle these components (see the section, "Antistatic Precautions").
____________________________________________________________
You may need to remove memory modules to either remove or install another memory
module. Note the position of any memory modules that you remove.
Figure 5-3 shows the removal procedure for a memory module. To remove a memory
module:
1. Remove the appropriate memory modules by pressing the metal clips (1) on each side
of the memory module connector.
2. Tilt the memory module and lift it (2) out of its connector.
__________________________ Note _____________________________
Memory modules can only be removed and installed in successive order. For
example, to remove a module at bank 0, you must first remove modules 0 and 1
for banks 3, 2, and 1.
____________________________________________________________
5-6 AlphaServer 1000A Rackmount Owner's Guide