Table of Contents
Advertisement
The set and show commands and a sample display are shown in Example 6-5..
Example 6–5: The set and show Commands
>>> set bootdef dev ewa0
>>> show bootdef_dev
ewa0
>>> show auto_action
boot
>>> set boot_osflags 0,1
>>>
__________________________ Note_____________________________
Remember to switch back to the Windows NT (ARC) console before booting the
Windows NT operating system.
____________________________________________________________
Memory
The system unit supports 20 single in-line memory modules (SIMM) on the system board.
The SIMM modules are grouped in four memory banks consisting of five modules: four
memory modules plus one memory module in each bank for ECC (Error Correction Code).
Figure 6-13 shows the memory bank groupings on the system board.
A minimum of one memory bank (five modules) is required.
_________________________Warning ___________________________
Before installing a memory module, turn off all power to the system. Refer to
"Turning the System Off" in Chapter 4, "Basic Operation" for information about
turning off power.
____________________________________________________________
Configuring Your System
AlphaServer 1000A Rackmount Owner's Guide 6-11
Advertisement
Table of Contents
Troubleshooting
