Installing The Cpu Card; Removing/Replacing Other Options - Compaq AlphaServer 1000A Owner's Manual

Installing the CPU Card

To install the CPU card, refer to Figure 5-12 and perform these steps:
1. Slide the card into its designated slot on the system board. Make sure it slips entirely
into the slot.
2. Press inward on the handle clips on each end of the card until they catch in a closed
position.
3. Place the crossbar in position and screw in the single retaining screw.

Removing/Replacing Other Options

The following components should be installed by a qualified service representative only:
•
System board
•
System fan
•
Interlocking sensor switch
•
Operator control panel
For assistance in removing or installing these components, contact your authorized service
representative.
Installing and Removing Components
AlphaServer 1000A Rackmount Owner's Guide 5-23