The Show Config Command - Compaq AlphaServer 1000A Owner's Manual

The show config Command

The show config command displays all devices found on the system bus, PCI bus, and
EISA bus. (See Example 6-2) You can use the information in the display to identify target
devices for commands such as boot and test, as well as to verify that the system sees
all the devices that are installed. Figure 6-1 shows the system board connectors and slots.
The configuration display includes the following information:
1. Version numbers for the firmware code, PALcode, SROM chip, and CPU; CPU speed
2. Memory size and configuration for each bank of memory
3. PCI bus information:
Bus 0, Slot 7 = PCI to EISA bridge chip
Bus 0, Slot 8 = PCI to PCI bridge chip
Bus 2, Slot 0 = SCSI controller on backplane, along with storage drives on the
bus.
Bus 2, Slots 1-4 = Correspond to physical PCI option module slots on the
secondary PCI bus:
In the case of storage controllers, the attached devices are also displayed.
Bus 0, Slots 11-13 = Correspond to physical PCI option module slots on the
primary PCI bus:
In the case of storage controllers, the attached devices are also displayed.
4. EISA bus information: Slot numbers correspond to EISA option module slots
(1 and 2). For storage controllers, the attached devices are also displayed.
Slot 1 = PCI1
Slot 2 = PCI2
Slot 3 = PCI3
Slot 4 = PCI4
Slot 11 = PCI11
Slot 12 = PCI12
Slot 13 = PCI13
AlphaServer 1000A Rackmount Owner's Guide 6-5
Configuring Your System