Basic Operation
The set secure Command
Use the set secure command to enable the security features without restarting the
console. If the console password has already been set, access will be limited to the
start, continue, boot (using the stored parameters), and login
commands. For example: >>> set secure
Console is secure
If the password has not been set, the console will prompt you to set it. (See "The set
password Command" section.)
>>> set secure
Secure is not set.
The set password Command
Use the set password command to set or change the console password. If the
password has already been set, the console prompts you for the new password and
verification, the for the old password.
>>> set
Please enter the password:
Please enter the password again:
Now enter the old password:
>>>
__________________________ Note _____________________________
The password length must be between 15 and 30 alphanumberic characters.
Any characters after the 30th are not stored.
____________________________________________________________
If the validation password does not match the one previously set, the password does not
change.
>>> set
Please enter the password:
Please enter the password again:
Validation error
4-14 AlphaServer 1000A Rackmount Owner's Guide
Please set the password.
password
password