Removing An Option Card; Testing An Option Card Installation - Compaq AlphaServer 1000A Owner's Manual

Rackmount

Table of Contents

Installing and Removing Components

Removing an Option Card

To remove an EISA, ISA, or PCI option card from the system unit, refer to Figure 5-7 and

perform these steps:

_________________________Caution____________________________

Static electricity can damage electronic components. Use an antistatic wriststrap

when you handle these components. See the section "Antistatic Precautions."

____________________________________________________________

1. Disconnect any cables connected to the external or internal ports on the option card

you want to remove.

2. Remove the slot cover screws (2) securing the option card to the chassis.

3. Carefully disconnect the option card (1) from the slot connectors on the system board

and remove it from the system.

4. If you intend to leave the option slot vacant, install a slot cover and secure it to the

chassis using the screw you removed.

5. When you finish removing or installing internal options, reassemble the system

following the procedure described in "Replacing the Top Panel," earlier in this

chapter.

To test an option card installation, perform the steps in Table 5–1 and refer to

Example 5–1.

_________________________Caution____________________________

Reassemble the system following the procedures listed in "Replacing the Top

Panel."

____________________________________________________________

5-12 AlphaServer 1000A Rackmount Owner's Guide

Table of Contents