Configuring Your System
The set and show Commands
The set and show commands are used to set environment variables. Typically, you set
environment variables when you configure a system.
_________________________Caution____________________________
Environment variables must be entered exactly as shown, not abbreviated. They
will not be recognized by the system in abbreviated form.
____________________________________________________________
Synopsis:
set envar value [-default] [-integer] [-integer] -[string]
show envar
Arguments:
envar
value
Options:
-default
Restores variable to its default value.
-integer
Creates variable as an integer.
-string
Creates variable as a string (default).
__________________________ Note _____________________________
Use the init command to initialize the firmware whenever you reset the
following environment variables: auto_action, console, language,
Example: >>> set os_type NT
____________________________________________________________
6-10 AlphaServer 1000A Rackmount Owner's Guide
The name of the environment variable to
be modified (auto_action, bootdef_dev,
boot_file, boot_osflags).
The value that is assigned to the
environment variable.
os_type, bus_probe_algorithm.
>>> init