Create Ipv6Route Default; Delete Ipv6Route Default - D-Link DGS-1210/ME series Reference Manual

Restrictions
Example usage:
To configure the retrans_time of IPv6 ND neighbor solicitation to be 100:
DGS-1210-28P/ME:5# config ipv6 nd ns ipif System retrans_time 100
Command: config ipv6 nd ns ipif System retrans_time 100
Success.
DGS-1210-28P/ME:5#

create ipv6route default

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To add a single static IPv6 entry in IPv6 format:
DGS-1210-28P/ME:5# create ipv6route default 3ffc::1
Command: create ipv6route default 3ffc::1
Success.
DGS-1210-28P/ME:5#

delete ipv6route default

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To o delete a static IPv6 entry from the routing table:
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
other command will also change so that the values in both
commands are the same. The range if 1 to 3600.
Only Administrator or operator-level users can issue this command.
Used to create IPv6 route entries to the Switch's IP routing table.
create ipv6route default <ipv6addr>
This create ipv6route default command is used to create a primary
and backup IP route entry to the Switch's IP routing table.
<ipv6addr> – Specify the IPv6 address to be creted.
Only Administrator or operator-level users can issue this command.
Used to delete a static IPv6 route entry from the Switch's IP routing
table.
delete ipv6route default
This delete ipv6route default command will delete an existing static
IPv6 entry from the Switch's IP routing table.
None.
Only Administrator or operator-level users can issue this command.
366