Appendix 7 - Logged Events And Where They Are Displayed - Honeywell touchpoint Pro Operating Instructions Manual

MAN0923_Issue 3_04/15
20. Appendix 7 - Logged events and
where they are displayed
All of the events listed below are captured in the Event History of the system. In addition, some are displayed
on the Active Events, Input/Output Details, or Inputs/Outputs screens as appropriate. Each event is logged
with a timestamp and if applicable the module or channel to which it applies.
Note: ADC – Analogue to Digital Converter
AIM – Analogue Input Module
CCB – Control Centre Board
COB – Communication Board
DIM – Digital Input Module
FW – Firmware
HMI – Human Machine Interface (User Interface)
I/O – Input/Output
UI/LHMI – Local User Interface (Touchscreen)
ROM – Relay Output Module
SW – Software
Event
49th Module present
49th Module removed
Accept Button Password Setting
Modified
Active Fault
Active Fault Cleared
Active Warning
Active Warning Cleared
ADC Error
ADC Error Cleared
AIM Fault Acknowledged
AIM mA Channel Modified
AIM mV Channel Modified
AIM Warning Acknowledged
Alarm
Alarm 1
Alarm 1 Acknowledged
Alarm 1 Cleared
Alarm 2
Alarm 2 Acknowledged
Alarm 2 Cleared
Alarm 3
Comment
System has detected that too many
I/O modules are connected
The Accept button on the Touchpoint
Pro front panel can optionally be
password protected – the setting
has been changed
Raised for hardware error in IO
Module channel diagnostics
Where Displayed
Input Output
Details Details
screen screen
✔
✔
✔
✔
✔
230
Touchpoint Pro
Operating Instructions
Specific
Active Inputs /
Channel Type
Events Outputs
(if applicable)
screen screen
✔
✔
✔
DIM
DIM
✔ ✔
✔ ✔ mA, mV
mA, mV
mA, mV
✔ ✔ mA, mV
mA, mV
mA, mV
✔ ✔ mA, mV