Fault Signalling Settings 1 - Honeywell touchpoint Pro Operating Instructions Manual

MAN0923_Issue 3_04/15
15. Appendix 2 - Configurable
Parameter Reference Guide

15.1.22 Fault Signalling Settings 1

Access Level: Engineer
Parameter Name
Custom Transmitter Fault
1 Enable
Custom Transmitter Fault
2 Enable
Custom Transmitter Fault
3 Enable
15.1.23 Fault Signalling Settings 2
Access Level: Engineer
Parameter Name
Custom Transmitter Fault 4
Enable
Custom Transmitter Fault 5
Enable
15.1.24 Custom Fault "X" Detail Settings
The Fault details can be set for each of the enabled custom faults.
Access Level: Engineer
Parameter Name
Custom Transmitter Fault
(1-5) Name
Custom Transmitter Fault
(1-5) Level Max
Custom Transmitter Fault
(1-5) Level Min
Custom Transmitter Fault
(1-5) Latch
Custom Transmitter Fault
(1-5) Definition
Default Setting Value Range
Disabled Enabled / Disabled
Disabled Enabled / Disabled
Disabled Enabled / Disabled
Default Setting Value Range
Disabled Enabled / Disabled
Disabled Enabled / Disabled
Default Setting Value Range
"Custom Fault 1" Maximum 20 Alphanumeric
Characters
3.0 mA 1.0 to 3.9 mA
2.0 mA 0.8 to 3.8 mA
Latching Non-Latching / Latching
Fault Fault / Warning
Comment
If enabled, a specific signal level from the sensor will activate a
custom fault condition for the channel. An example of a custom
fault is the "Beam Block" condition for an open path IR detector
Comment
If enabled, a specific signal level from the sensor will
activate a custom fault condition for the channel. An
example of a custom fault is the "Beam Block" condition
for an open path IR detector
Comment
This is the fault description, which will be displayed
on the "Input Details" screen
The recommended minimum difference between
Fault Level Max and Fault Level Min is 0.2 mA
Select whether the "custom fault" should be treated
as a fault condition or as a warning condition.
200
Touchpoint Pro
Operating Instructions