Checking The Common Setup Information; Setting Up Scan To E-Mail And Internet Fax - Oki MC361dn User Manual

Configuring the Network Settings
Checking the Common Setup
Information
Check the common setup information for Scan To
E-mail, Scan To Network PC and Internet Fax,
and fill in the corresponding columns of the
Setup Information Form.
 Administrator Password for Your
Machine
Enter the administrator password of your
machine in A-1 of the Setup Information Form.
If you are not the administrator of the machine,
ask the administrator the password.
Memo
 Passwords are case-sensitive.
 The administrator password is set to "aaaaaa" as the
factory default setting.
 Gateway address/DNS server
Press the <SETTING> key on the
1
operator panel.
Check that [Reports] is selected and
2
press .
OK
Check that [Configuration] is selected
3
and press .
OK
On the confirmation screen press
4
select [Yes], and press
Enter the address written on the gateway
5
address line at the bottom right of page
3 of the printed configuration into A-2 on
the setting information sheet, and enter
the address written on the DNS server
(primary) line on the bottom right of the
same page into A-3.
Note
 It is necessary that the gateway address be configured
beforehand. Also, if using an internet service provider, it is
necessary that the DNS server be configured. If it has not
been configured (0.0.0.0), follow the 34 page procedure to
configure it.
or ,
.
OK
- 46 -
Setting Up Scan To E-mail and
Internet Fax
The Scan To E-mail and Internet Fax functions
enable you to send scanned images as an
attached file of an e-mail to the specified e-mail
address on the network.To use these functions,
set up the e-mail setting for your machine.
When using Auto Deliver or Transmission Data
Save function (MC561dn only), the following
setup is required.
Checking the E-mail Settings of the
Computer
Note
 If a network administrator specifies the values such as a
mail server account, password and e-mail address for your
machine, enter them in the Setup Information Form.
Memo
 The procedure below uses Windows Live Mail on Windows
7. If you are using different mail software, refer to the
manual for the e-mail software.
Click [Start] and select [Windows Live
1
Mail].
Select the [Tools] menu > [Accounts].
2
If the menu bar is not displayed, click the
[Menus] icon and then select [Show menu bar].
Select the mail account and then click
3
[Properties].