Fluke 9190A Operator's Manual page 77

SENS2:CAL:PAR<n>[?] [cal] (-P model only)
This command is unconditionally protected, that requires a password to set it.
Read or set the UUT input calibration parameter for the selected function. "n" is an integer 1-6.
PAR1=TCC0, PAR2=TCC100, PAR3=TCCRJ, PAR4=mAC4, and PAR6=mAC22 respectively.
"cal" is a real number used as the calibration offset for the respective parameter.
UUT input commands to verify or set TCC0 (PAR1), TCC100 (PAR2), TCCRJ
(PAR3) for the thermocouple (TC) function calibration parameters and mAC4 (PAR4), and
mAC20 (PAR6) for the mili-amp (mA) function calibration parameters.
Range:
TC = ± 10.00 (mV)
mA = ± 4.00 (mA)
Default:
TC = ± 0.00 (mV)
mA = ± 0.00 (mA)
Read Example:
SENS2:CAL:PAR1?
Response:
0.2
Set Example:
SENS2:CAL:PAR2 0.092
SENS2:DATA? (-P model only)
Read the UUT input. The returned value depends on the set function. PRT/RTD will be in
resistance, TC will be in mV, mA will be in mA. This command returns the UUT input in ohms
for the PRT/RTD function, mV for the thermocouple function, and mA for the current loop
function.
Example:
SENS2:DATA?
Response:
0.03
SENS2:FUNC[?] [par] (-P model only)
Read or set the UUT Sense Function (device) selection. "par" is the selected device and is entered
as RTD, TC or MA.
Default = RTD. This command reads or sets the UUT Sense Function as, RTD, TC, or mA.
Read Example:
SENS2:FUNC?
Response:
RTD
Set Example:
SENS2:FUNC TC
SOUR:LCON:DER[?] [n]
This command is unconditionally protected, that requires a password to set it.
Read or set the main control loop derivative time in seconds. The main zone derivative is the
derivative time in seconds that the instrument's PID controller uses for main zone control.
Range = {Min: 0.0, Max: 99.9}
Read Example:
SOUR:LCON:DER?
Response:
1.5
Set Example:
SOUR:LCON:DER 5
Note
Note
Remote Operation
Remote Operation Commands
3
3-21