Communication Setup - Fluke 9190A Operator's Manual

Communication Setup

To use the RS-232 Remote Serial Interface, the Calibrator must be configured to
communicate with the computer. Configuration is done in the Communication Setup
menu on the Calibrator.
S Y S T E M
MENU
MENU
Item
BAUD RATE is the serial communication transmission rate or baud rate. BAUD may be set to

1200, 2400, 4800, 9600, 19200, or 38400 baud.
LINEFEED turns on or turns off transmission of a line feed character (LF, ASCII 10) after

transmission of any carriage-return.
Set up communications as follows:
1. Push .
2. Push .
3. Push .
4. Push .
BAUD RATE
5. Highlight
6. Push  or  to change the
Set the BAUD RATE to the baud rate that the computer serial port is
configured for.
7. Push  to save.
Table 3-2. Communication Setup Menu
S Y S T E M C O M M
S E T U P S E T U P
Function
and push .
BAUD RATE
(see item  in Table 3-2).
Note
Remote Operation
Remote Operation Setup
66.03°C
C O M M U N I C A T I O N S E T U P
BAUD RATE: 9600
LINEFEED: ON
3
1
2
gzs016.eps
3-5