Rtd Setup - Fluke 9190A Operator's Manual

9190A
Operators Manual

RTD Setup

Table 2-25 shows and describes the menu selections on the RTD Setup menu.
The selections in the SETUP INPUT menu is dependent on the Sensor Type
selected in the SELECT INPUT menu. The SETUP INPUT menu is used to
set up the UUT input or to run the test algorithm.
MENU
Item
WIRES configures the RTD input for a 2, 3, or 4-wire input.

RTD TYPE sets up the conversion type for the RTD. RTD characterization types include
PT100(385), PT100(392), PT100(ITS), NI-120, and RESISTANCE.

2-24
Table 2-25. RTD Setup Menu
I N P U T S E T U P
S E T U P I N P U T
When RESISTANCE is selected the RTD resistance is shown instead of
temperature.
Note
66.03°C
R T D
S E T U P
RTD TYPE: RESISTANCE
Function
Note
R T D S E T U P
WIRES: 3
1
2
gzs027.eps