Safety Information - Fluke 9190A Operator's Manual

9190A
Operators Manual

Safety Information

A Warning identifies conditions and procedures that are dangerous to the user. A
Caution identifies conditions and procedures that can cause damage to the Product or the
equipment under test.
See Table 1-1 for a list of symbols used in this manual and on the Calibrator.
Symbol
To prevent possible electrical shock, fire, or personal injury:
•
•
•
•
•
•
•
•
•
•
1-4
Description
Conforms to European Union

directives
Risk of Danger. Important

information. See manual.

Earth ground
This product complies with the WEEE Directive (2002/96/EC) marking requirements.
The affixed label indicates that you must not discard this electrical/electronic product
in domestic household waste. Product Category: With reference to the equipment

types in the WEEE Directive Annex I, this product is classed as category 9 "Monitoring
and Control Instrumentation" product. Do not dispose of this product as unsorted
municipal waste. Go to Fluke's website for recycling information.
Read all safety Information before you use the Product.
Use the Product only as specified, or the protection
supplied by the Product can be compromised.
Use this Product indoors only.
Do not use the Product around explosive gas, vapor, or in
damp or wet environments.
Do not use and disable the Product if it is damaged.
Use only the mains power cord and connector approved for
the voltage and plug configuration in your country and rated
for the Product.
Replace the mains power cord if the insulation is damaged
or if the insulation shows signs of wear.
Make sure the ground conductor in the mains power cord is
connected to a protective earth ground. Disruption of the
protective earth could put voltage on the chassis that could
cause death.
Do not put the Product where access to the mains power
cord is blocked.
Use caution when you install and remove probes and
inserts from the Product. They can be hot.
Table 1-1. Symbols
Symbol



 Warning
Description
Conforms to relevant North
American Safety Standards.
Conforms to relevant Australian
EMC requirements
Hazardous voltage