Attaching Fascia Assembly - Rinnai RDV600ER Installation Manual

ATTACHING FASCIA ASSEMBLY

Step 8. Attach the Fascia to the Heater Engine
E
The fascia is mounted to the engine via five, (i), (ii) (iii), (iv) & (v) mounting points. Points (i) & (ii) are fastened
using 8g x 10mm sheet metal screws, (B). Points, (iii), (iv), (v) are fastened using 4mm metal threaded screws,
(B1) at points (A1).
All these screws have been pre-inserted by the manufacturer to ensure correct threading of the
fascia securing points. Remove screws (B) only prior to fitting the fascia.
NOTE
•
Carefully pick up fascia assembly and position it in front of the heater engine, connect the RJ45 plug (C) into
the socket (D) located on the back of fascia on the bottom left hand corner, (this connects the push button
control panel via a communications cable to the heater engine's control box).
•
Guide the tabs (E), into the fascia assembly mounting slots (F).
•
Ensure the three slots in the inner fascia panel have slid over all three screws (B1).
•
Insert the two 8g x 10mm sheet metal screws, (B), through the fascia mounting holes at points, (A) at the
bottom left and right and partially tighten.
•
Fully tighten the three top screws, (B1) while gently pushing the fascia against the appliance to ensure a
close fit, a 7mm open ended spanner will be needed.
•
Gently push the fascia at the bottom corners while fully tightening the two screws, (B).
•
Fitting the fascias is now complete.
Ensure you DO NOT place excessive tension on or pinch the communication cable (C) when
manoeuvring the fascia into position.
NOTE
The glass of the fascia fitted to this appliance reduces the risk of fire and injury and no part of it
should be permanently removed.
NOTE
For protection of young children or the infirm a secondary guard is required.
Rinnai
E
A
iii
F
i
D
i
B
B
A1
iv
F
v
B1
iii
C
ii
31
COMMISSIONING
ii
A1
A
B1
A
B1
iv v
B
A1
A1
B1
A
B
RDV 600_700ER IM