Changing Parameter Settings Using Ams Device Manager; Operation - Siemens Sitrans LR200 Instruction Manual

6) Click on the Breakpoints tab and enter values for level and volume for up to 32
breakpoints.
7) Navigate to Configure/Setup > Setup > Linearization and click on Characteristic to
preview the characteristic curve of the vessel breakpoints.
8) In Step 5 – Summary check parameter values. Click on the appropriate step menu to
return and revise values, or click on a different menu to exit Quick Start.

Changing parameter settings using AMS Device Manager

Notes:
• For a complete list of parameters, see
• For more detailed explanations of the parameters listed below see the pages
referenced.
1) Adjust parameter values in the parameter value field in Configure/Setup view, then
click on Apply to write the new values to the device. The parameter field will display
in yellow until the value has been written to the device.
2) Click on OK only if you wish to update all parameters and exit AMS.

Operation

Navigate to Configure/Setup > Operation and click on Operation to open the dialog window for
access to:
General:
• Select Analog Output (see
• Master Reset (see
Simulation/Test
• Self Test (see
• Loop Test (see
7ML19985JP02
Select Analog Output
Master Reset
Self Test
on page 51)
Loop-Test
on page 52)
SITRANS LR200 (HART) – INSTRUCTION MANUAL
Parameter Reference
on page 51)
on page 52)
on page 74.
Page 61