Explosion-Proof Wiring (Fm/Csa Us/Canada Only); Instructions Specific To Hazardous Area Installations - Siemens Sitrans LR200 Instruction Manual

5. Explosion-proof wiring (FM/CSA US/Canada only)

FM/CSA Explosion Proof connection drawing
number 23650597 can be downloaded from the product page of our website at:
www.siemens.com/LR200.
• For power demands see
page 138.
• For wiring requirements (North America only) see the connection drawing listed
above.
Instructions specific to hazardous area
(Reference European ATEX Directive 94/9/EC,
The following instructions apply to equipment covered by certificate numbers
1) For use and assembly, refer to the main instructions.
2) The equipment is certified for use as Category 1G equipment.
3) The equipment may be used with flammable gases and vapors with apparatus group
IIC, IIB, and IIA, and temperature classes T1, T2, T3, and T4.
The equipment is certified for use in an ambient temperature range of –40 °C to
4)
+80 °C.
5) The equipment has not been assessed as a safety related device (as referred to by
Directive 94/9/EC Annex II, clause 1.5).
6) Installation and inspection of this equipment shall be carried out by suitably trained
personnel in accordance with the applicable code of practice (EN 60079-14 and
EN 60079-17 in Europe).
7) The equipment is non-repairable.
8) The certificate numbers have an 'X' suffix, which indicates that special conditions
for safe use apply. Those installing or inspecting this equipment must have access
to the certificates.
7ML19985JP02
Curve 2 (Flameproof, Increased Safety, Explosion-proof)
installations
Annex II, 1/0/6)
SIRA 06ATEX2378X, SIRA 05ATEX1001X:
SITRANS LR200 (HART) – INSTRUCTION MANUAL
(continued on next page)
Page 25
on