System Requirements - Alcatel speed touch home Advanced User's Manual

2 Speed Touch Tour
2.3

System Requirements

ADSL
ATM
Remote Organization
Ethernet
18 / 180
The Speed Touch Home requires the following hardware and
system configuration:
ADSL service must be enabled on your telephone line. Read
Chapter 4 first for instructions.
The ADSL modem relies on ATM Technology for its wide area
communications. Refer to section 14.1 for advanced information.
All packet services use ATM's Virtual Channel (VC)s for accessing
the ADSL Line. Virtual Path Identifier (VPI)/Virtual Channel
Identifier (VCI) are 2 numbers that together uniquely identify a
VC.
Therefore, the parameters on which the packet service is enabled
in the STHome, must match with the following information from
your remote organization:
The type of protocol(s) that are supported at the remote end
"
of the ATM virtual connections.
The ATM/AAL5 encapsulation type (per protocol) that is
"
configured at the remote end of the connection.
In the event of STHome default differences, change them via the
local web pages (See Chapter 12).
The VPI and VCI values of the VCs, default cross connected
between the ADSL Line and the packet service's interface, are
listed in Appendix C.
Additionally, the remote organization may provide you with:
A User Account, i.e. User Name and Password, for Internet
"
access via an ISP or corporate location access.
Additional User Accounts might be required for access to
specific secured servers.
A Personal Computer (PC)/workstation with an Ethernet
"
10Base T PC Network Interface Card (NIC) installed;
For local networking, a 10Base T hub and the necessary
"
connection cables.
3EC 17096 AAAA TCZZA Ed. 01