Alcatel speed touch home Advanced User's Manual page 103

TIP
Note
3EC 17096 AAAA TCZZA Ed. 01
8. If successful, the STHome has configured this IP address and
will reply to the ping.
9. You may clear the entry in the ARP cache by issuing
the following command:
arp –d <STHome IP address>
Leaving the entry in the ARP cache does not harm the general
operation.
'Ping -t' command
You can avoid waiting 30 and then 60 seconds by proceeding as
follows:
1. If step 5. of the previous procedure is executed, continue as
below:
2. Ping the IP address with the command:
ping –t <STHome IP address>.
6. Turn on the STHome.
7. After the selftest, the STHome will reply to the ping.
8. Terminate the continuous ping by pressing CTRL C.
If your PC is equipped with multiple PC NICs, make sure that the
procedure is applied to the one connected to the STHome.
Therefore modify the arp syntax as follows:
arp –<a, s, d> <STHome IP address>
–N <interface IP address>
In this syntax, <Interface IP address> identifies the
particular PC NIC.
11 Lost Speed Touch
103 / 180