Push Button - Alcatel speed touch home Advanced User's Manual

11 Lost Speed Touch
Note
11.2.2

Push Button

CAUTION
106 / 180
5. You must clear the entry in the ARP cache by issuing
the following command :
arp –d <IP address within subnet>
The IP address used to perform a Ping to Defaults is not
assimilated by your Speed Touch Home. The STHome will restart
with the original defaults, including the default IP address
10.0.0.38.
6. If needed, reconfigure the STHome's IP address.
The small push button entitled "Defaults" is located on the rear
panel of the STHome.
The procedure to revert all of the STHome configurable values
back to their original defaults is as follows:
Push Button vs. Internal Settings
Attention is required when using the push button as it will
overwrite all previous settings and changes them to the original
values.
1. Use a pencil to press the push button at the back of the
STHome;
2. Release the button. Via the flashing front panel LEDs, you will
notice that the STHome will reboot.
3. Finally, it will come online with the original defaults.
4. If needed, reconfigure the STHome's IP address.
3EC 17096 AAAA TCZZA Ed. 01