Ping To Defaults - Alcatel speed touch home Advanced User's Manual

11.2.1

Ping to Defaults

CAUTION
CAUTION
3EC 17096 AAAA TCZZA Ed. 01
The first method to reset all settings to the original defaults is
the Ping to Defaults.
The technique is identical to that used for the Ping of Life, except
that another MAC address is used, i.e. 01–90–D0–80–01–FF.
Ping to Defaults vs. Internal Settings
Attention is required when performing a Ping to Defaults as it will
overwrite all previous settings and changes them to the original
default values.
The following steps will cause the SThome to revert to the default
values:
1. Add the following to the ARP cache:
arp –a <IP address within subnet> 01-90-D0-80-01-FF
This <IP address within subnet> can be any address
within your subnet as long as it is not used by any other
member of your local network.
IP Addresses and Subnet Masks
Make sure that the intended STHome IP address and your PC
share the same IP (sub)network.
If not, the ping will be submitted with the MAC address of the
default router, instead of the special MAC Group address.
2. Turn of the STHome and turn it on again.
3. The STHome performs a self test. Wait for the self test to end.
4. Ping the IP address you have chosen in step 1.:
ping <IP address within subnet>
11 Lost Speed Touch
105 / 180