Leds - Alcatel speed touch home Advanced User's Manual

2 Speed Touch Tour
2.2.4

LEDs

Note
16 / 180
As seen in figure 2, the Speed Touch Home is equipped with 5
Light Emitting Diodes (LEDs) on its front panel.
Following table explains the functions of the LEDs:
Table 1 STHome LED Status Overview
Indicator
Name Color State
LAN green flashing
Line TX green flashing
Line RX green flashing
Sync green on
PWR/Alarm green on
red
There is also one LED on the rear panel.
It indicates the state of the Ethernet wiring (See figure 3).
Assuming the STHome and PC are properly connected and
powered on, this LED should be continuously green.
Explanation
data is flowing from/to the
Ethernet interface
off no activity on the Ethernet inter
face
ATM cells are being sent over
the ADSL line
off no transmission activity
ATM cells are being received via
the ADSL Line
off no reception activity
ADSL line synchronization
achieved
flashing during initialization of the ADSL
line
power on, normal operation
flashing power on, selftest pending
on power on, selftest failed
3EC 17096 AAAA TCZZA Ed. 01