Initial Setup Page - Alcatel speed touch home Advanced User's Manual

12 Speed Touch Home Local Configuration
12.1.3

Initial Setup Page

112 / 180
Figure 61 'Initial Setup' Web Page
The Speed Touch Home relies heavily on the TCP/IP Protocol for
its internal operation. IP requires a minimum set of parameters for
its proper operation:
IP address
"
Netmask
"
These parameters can be configured manually using this 'Initial
Setup' page, or automatically via the 'DHCP Configuration' page
(See section 12.1.9 for more).
These IP parameters are for local communication only.
As the STHome IP layer supports logical multi homing (one
interface supporting multiple IP addresses), the manually
configured IP address and the automatically required IP address
are both active at the same time.
Parameters on this page (See also figure 61):
Speed Touch Home MAC address
"
The unique Medium Access Control (MAC) address of the
STHome is displayed as Initial setup for xx xx xx xx xx xx".
It is used to identify your STHome on the LAN.
3EC 17096 AAAA TCZZA Ed. 01