Bridging Configuration; Remote Organization - Alcatel speed touch home Advanced User's Manual

6 IEEE 802.1D Transparent Bridging
6.4

Bridging Configuration

6.4.1

Remote Organization

Note
CAUTION
44 / 180
The remote access server must support:
RFC1483 Bridged PDU Encapsulation on ATM.
"
Additionally the remote organization must provide you with:
the VPI/VCI values of the virtual channels on which the
"
Bridging service is enabled. In the event of default differences
(see table 3 for Speed Touch Home's original
cross connections), adapt them using the local web pages as
described in Chapter 12.
In case of Internet access, IP parameters to be supplied
"
for your PC(s) are:
The PC's own IP address;
D
A Subnet Mask;
D
The IP address of the default gateway;
D
The IP addresses of the primary and secondary Domain
D
Name System (DNS) server;
The local DNS Domain name;
D
Optionally, the IP addresses and port numbers of proxy
D
servers.
Should you want connectivity to multiple remote organizations,
additional sets of these parameters need to be supplied.
Remote organization may distribute IP parameters automatically,
e.g. via Dynamic Host Configuration Protocol (DHCP). If so, it will
require you to configure your PC(s) to support this automatic
procedure. See section 9.4.3 for more information.
Bridging and DHCP
DHCP is by default disabled for the STHome. This is to avoid
conflicts with the DHCP server of your Internet Service
Provider (ISP).
3EC 17096 AAAA TCZZA Ed. 01