Table of Contents
Advertisement
IP NETWORKING CARD
(IX-8IPNET / IX-8EIPNET)
The IX-8IPNET/IX-8EIPNET IP Networking card provides 8 ports for IP
Networking use. The IX-8EIPNET is a daughterboard that can receive
power from either the IX-8IPNET (for a combined total of 16 IP Networking
ports) or the IX-8IPSUB (for a combined total of 8 IP Networking ports and
8 IP station ports). The IX-8IPNET / IX-8EIPNET IP Networking card
interfaces with the Ethernet-based local area network (LAN) using one port
on the LAN switch (or router if no switch is used) before passing the voice
traffic over a fully managed network (such as a VPN).
The IX-8IPNET / IX-8EIPNET IP Networking cards use Session Initiated
Protocol (SIP) to establish a connection on an as-needed basis.
Ports: 8 ports/card
Additional Power: None
Voice Compression: G.711 or G.729
E & M TIE LINE NETWORKING INTERFACE CARD
(IX-4EMTK)
The IX-4EMTK card interfaces the Iwatsu Enterprise-CS to four circuits for
four wire E&M tie lines for system-to-system connection. Either Type 1 or
Type 2 E&M can be selected as required by the customer.
Ports: 4 ports/card
Additional Power: 48 VDC (IX-DCDCM)
Features: Type 1/Type 2 selection
FIC Code: Type 1: TL31M
Type 2: TL 32M
T1 TRUNK INTERFACE CARD
(IX-DTI-T)
The IX-DTI-T card interfaces the Iwatsu Enterprise-CS to one T1 span and
has the ability to support the following configurations: loop start trunk,
ground start trunk, E&M trunk, E&M tie, DID trunk, ANI trunk, DNIS
trunk, single line telephone, and off-premise telephone. In addition, the card
may be configured to provide the following clocking options: Master,
Slave-Primary, Slave-Backup or Slave-Private. The IX-DTI-T is not
supported in the IX-CME when the IX-T1RCV Receiver card is required.
Ports: 8, 16, 24 ports/card
Features: loop, ground, E&M trunk, E&M tie, DID, ANI, DNIS, OPX, SLT
GENERAL DESCRIPTION - 45
Advertisement
Table of Contents
