Removing A 3.5-Inch Drive Adapter From A 3.5-Inch Drive Carrier - Dell PowerEdge T360 Installation And Service Manual

Figure 29. Installing a drive into the drive carrier
Next steps
1. Install the drive carrier.
2. Install the front bezel.

Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier

Prerequisites
1. Follow the safety guidelines listed in
2. Remove the drive carrier.
Steps
1. Remove the screws from the rails on the drive carrier.
NOTE: If the 3.5-inch drive has Torx screw, use Torx 6 screwdriver to remove the drive from a 3.5-inch drive adapter.
2. Lift the 3.5-inch drive adapter out of the drive carrier.
70 Installing and removing system components
Safety instructions.