How to Set Up an IPv6-in-IPv4 Tunnel
This example shows how to configure your ZyWALL/USG to create IPv6-in-IPv4
Tunnel. In this example, the ZyWALL/USG acts as IPv6-in-IPv4 routers which connect
the IPv4 Internet and an individual IPv6 network. This configuration example only
shows the settings on ZyWALL/USG_Z. You can use similar settings to configure
ZyWALL/USG_Y.
ZyWALL/USG with IPv6-in-IPv4 Tunnel Example
Note: All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using USG310 (Firmware Version: ZLD 4.25).
www.zyxel.com
721/749