How To Set Up An Ipv6 6To4 Tunnel - ZyXEL Communications ZyWALL 110 Handbook

Security firewalls zywall/usg series

Hide thumbs Also See for ZyWALL 110:

Table of Contents

How to Set Up an IPv6 6to4 Tunnel

This example shows how to configure your ZyWALL/USG to create IPv6 6to4 Tunnel.

In this example, the ZyWALL/USG acts as a 6to4 router which connects the IPv4.

After configuration, the ZyWALL/USG can assign an IPv6 to clients behind it and

pass IPv6 traffic through IPv4 environment to access remote IPv6 network.

ZyWALL/USG with IPv6 6to4 Tunnel Example

Note: All network IP addresses and subnet masks are used as examples in this article.

Please replace them with your actual network IP addresses and subnet masks. This

example was tested using USG310 (Firmware Version: ZLD 4.25).

www.zyxel.com

Show Quick Links

Table of Contents