Go to ZyWALL/USG_Branch CONFIGURATION > Network > Routing > Add. Set
Source Address to be the local subnet (192.168.10.0/24 in this example). Set
Destination Address to be the remote LAN subnet (192.168.2.0/24 in this example)
allows joining the VPN tunnel.
CONFIGURATION > Network > Routing > Add
Test the IPSec VPN Tunnel
Go to ZYWALL/USG CONFIGURATION > VPN > IPSec VPN > VPN Connection, click
Connect on the upper bar. The Status connect icon is lit when the interface is
connected.
CONFIGURATION > VPN > IPSec VPN > VPN Connection
Go to ZyWALL/USG MONITOR > VPN Monitor > IPSec and verify the tunnel Up
Time and Inbound(Bytes)/Outbound(Bytes) Traffic.
MONITOR > VPN Monitor > IPSec
www.zyxel.com
391/749