Test The Ipsec Vpn Tunnel - ZyXEL Communications ZyWALL 110 Handbook

Enter the command line in terminal mode (Using Tera Term in this example).
Tera Term command

Test the IPSec VPN Tunnel

8
Go to ZYWALL/USG CONFIGURATION > VPN > IPSec VPN > VPN Connection, click Connect
on the upper bar. The Status connect icon is lit when the interface is connected.
CONFIGURATION > VPN > IPSec VPN > VPN Connection
9
Go to ZyWALL/USG MONITOR > VPN Monitor > IPSec and verify the tunnel Up Time and
Inbound(Bytes)/Outbound(Bytes) Traffic.
MONITOR > VPN Monitor > IPSec
10
Go to ZyWALL/USG_Branch MONITOR > Log. Try to disconnect WAN1 interface (172.1.1.30.68)
and you will see the VPN tunnel failover to WAN2 interface (172.100.20.78).
MONITOR > Log
www.zyxel.com
240/749