Table of Contents
Advertisement
Annunciator
OUT F
This instruction outputs the operation result up to the OUT F instruction to the specified annunciator.
Ladder diagram
(d)
Setting data
■Descriptions, ranges, and data types
Operand
Remarks
(d)
Annunciator number that turns ON
■Applicable devices
Operand
Bit
X, Y, M, L,
U\G T, ST,
SM, F, B, SB
*1
(d)
*1 Only F can be used.
Processing details
• This instruction outputs the operation result up to the OUT F instruction to the specified annunciator.
• Operation is as follows when annunciator (F) is turned ON by the OUT F instruction.
• The annunciator number (F number) that turns ON is stored in special registers (SD64 to SD79).
• The content of SD63 is incremented by 1.
• When the content of SD63 is 16 (16 annunciators are already on), the annunciator number that turns ON is not stored in
SD64 to SD79 even if a new annunciator turns ON.
• Operation is as follows when annunciator (F) is turned OFF by the OUT F instruction:
• The coil turns OFF, but the contents of SD64 to SD79 do not change.
• To delete an annunciator that has turned OFF by the OUT F instruction from SD64 to SD79, use the RST F instruction.
Operation error
There is no operation error.
Structured text
ENO:=OUT(EN,d);
Range
Word
T, ST, C, D,
U\G
C, LC
W, SD, SW, R
Data type
Bit
Double word Indirect
specification
Z
LC
LZ
5 SEQUENCE INSTRUCTIONS
Data type (label)
ANY_BOOL
Constant
Others
K, H
E
$
113
5.3 Output Instructions
5
Advertisement
Table of Contents
