Mitsubishi MELSEC iQ-F FX5 series Programming Manual page 584

• The table below shows the related devices.
Device Name
SM8019 Real time clock error
Binary code
SD210 Binary clock data (year)
SD211 Binary clock data (month)
SD212 Binary clock data (day)
SD213 Binary clock data (hour)
SD214 Binary clock data (minute)
SD215 Binary clock data (second)
SD216 Binary clock data (day of the week)
Binary code (FX3 compatible area)
SD8013 Binary clock data (second)
SD8014 Binary clock data (minute)
SD8015 Binary clock data (hour)
SD8016 Binary clock data (day)
SD8017 Binary clock data (month)
SD8018 Binary clock data (year)
SD8019 Binary clock data (day of the week)
Precautions
• These instructions occupy seven points of device starting from device number specified by (s). Make sure that these
devices are not used by other machine controls.
Operation error
Error code Description
(SD0/SD8067)
2820 The device range specified by (s) exceeds the corresponding device range.
7 APPLICATION INSTRUCTION
582
7.19 Clock instruction
Description
This special data register turns on when the clock data value in the special register is exceeding the setting
range.
The year data in the clock data is stored as a four-digit binary code.
The month data in the clock data is stored as a binary code.
The day data in the clock data is stored as a binary code.
The hour data in the clock data is stored as a binary code.
The minute data in the clock data is stored as a binary code.
The second data in the clock data is stored as a binary code.
The day-of-a-week data in the clock data (0: Sunday, 1: Monday, ..., 6: Saturday) is stored as a binary code.
The second data in the clock data is stored as a binary code.
The minute data in the clock data is stored as a binary code.
The hour data in the clock data is stored as a binary code.
The day data in the clock data is stored as a binary code.
The month data in the clock data is stored as a binary code.
The year data in the clock data is stored as a four-digit binary code.
The day-of-a-week data in the clock data (0: Sunday, 1: Monday, ..., 6: Saturday) is stored as a binary code.