Mitsubishi MELSEC iQ-F FX5 series Programming Manual page 569

Precautions
• Do not change the contents of operands and data during operation.
• To execute these instructions again, set the command input to off once, then on again.
• These instructions can be used up to or twice in any program.
• When specifying the same device in (s) and (d), the source data is overwritten by the data acquired by sorting. Take special
care so that the contents of (s) are not changed until execution is completed.
• Ensure that the sorted data does not overlap with the source data.
D10 D30
Source Data
D2 D22
Sorted Data
D10 D30
Source Data
D10 D30
Sorted Data
D50
Source Data
D20
D40
Sorted Data
Operation error
Error code Description
(SD0/SD8067)
2820 The device range specified by (s) exceeds the corresponding device range.
The device range specified by (d) exceeds the corresponding device range.
3405 The value specified by (m1) is outside the following range.
1 to 32
The value specified by (m2) is outside the following range.
1 to 6
The value specified by (n) is outside the following range.
1 to (m2)
D10 D30
Source Data
D20 D40
Sorted Data
D10 D30
Source Data
D35
Sorted Data
D70
D55
7 APPLICATION INSTRUCTION
7.17 Data operation instruction
7
567