Table of Contents
Advertisement
Operation error
Error code
Description
(SD0/SD8067)
3405
The Xn data is not set in the ascending order in the data table.
However, the instructions before the occurrence of an error are executed.
The input value specified by (s1) is out of the range for the set scaling conversion data.
The value in the middle of operation exceeds the 32-bit data range.
In this case, verify that the distance between points is not "65535" or more.
If the distance is "65535" or more, reduce the distance between points.
The number of coordinate points from the device specified by (s2) is 0 or less.
7 APPLICATION INSTRUCTION
7.10 Data control instruction
7
489
Advertisement
Table of Contents
