The Machine Doesn't Run - Roland GR-640 User Manual

The Machine Doesn't Run

Are cables connected?
Check that the power cord and the USB cable/network cable to the computer are
connected correctly.
Is the power switched off?
Turn on the machine power.
Is the machine ready to receive cutting data?
If the display shows the following screen, cutting cannot be performed even when
data is sent.
Select the loaded material, press the [ENTER] key, and then set the machine so it is
ready to receive cutting data.
Are the software application settings incorrect?
Select the appropriate driver for the machine.
For the selection procedure, refer to the manual for the application software.
If the Machine Does Not Run Even after You Have Checked the Above
Points
Perform a self test. If the self test cannot be executed, the machine may have
malfunctioned.
Contact your authorized Roland DG Corp. dealer.
Checking the Machine Status (Self Test)