Table of Contents
Advertisement
Preventing Misaligned Cutting
Set this setting to [ON] to feed out the material automatically during cutting.
While this setting is enabled, when cutting data is sent from the computer, cutting is
performed every 1 meter after the material has automatically been fed forward
(depending on the data, the material may be fed out more than 1 m, for example if the
next movement point is more than 1 m back).
If material has already been fed out using the [AREA] function, the material will not be
fed out automatically until the length of material that was fed out using the [AREA]
function is reached, even if [PRE-FEED] is set to [ON].
* This function is only enabled when the material type has been set to [ROLL].
Procedure
Make sure the material is loaded in the machine.
Press [MENU] several times to display the screen
shown in the figure.
Press [ ] several times to display the screen
shown in the figure.
Press [ ].
Hide quick links:
Advertisement
Table of Contents
