Table of Contents
Advertisement
The Material Slips Away from the
Pinch Rollers during Cutting
Is the material loaded in parallel with the gradations of the ruler?
If the front edge of the material is cut at an angle, trim off an excess portion so that
the front edge is parallel with the gradations of the ruler, and then load the material.
Using Various Material Widths
Is the material making contact with some obstacle during cutting?
Make sure that the left and right edges of the material do not make contact with the
inner surfaces of the machine during cutting.
Such contact not only damages the material but also hinders normal material feed
and causes the material to slip out of position.
Was the material feed checked before cutting (for roll material)?
If you start cutting without checking the material feed, correct cutting results may
not be obtained if the material is not fed correctly. In the worst case, this problem
may cause an error or malfunction or damage to the material.
Loading Roll Material
Is the machine exposed to direct sunlight or strong indoor lighting?
Move the machine to a location where it is not exposed to direct sunlight or indoor
lighting.
Hide quick links:
Advertisement
Table of Contents
