Roland GR-640 User Manual page 8

* Conditions differ according to the type of blade.
Refer to "General Guide Regarding Cutting
Cuttable Area
Model name
GR-640
GR-540
GR-420
* The maximum width can be extended by up to 20 mm depending on settings.
However, this may cause the pinch roller to leave marks on the products. Exercise
caution. For instructions on how to extend the cutting area, refer to
Cutting Area <EXTEND>."
Explanation of Cutting Area
The cutting area along the material's horizontal plane (the direction in which the
cutting carriage moves) is determined by the position of the pinch rollers. The
cutting area spans the length between the two rollers, minus approximately 1 mm
on each side.
Type of specified material
[ROLL] or [EDGE]
[PIECE]
*: If the detected length is 1,600 mm or more, the machine determines the material
to be [ROLL], and the length of the cutting area is set to 24,998 mm.
However, the display does not show the length.
Conditions."
Maximum cutting area
Width: 1,651 mm (65 inches)(*)
Length: 24,998 mm
Width: 1,397 mm (55 inches)(*)
Length: 24,998 mm
Width: 1,075 mm (42.3 inches)(*)
Length: 24,998 mm
<Width>: Distance between the two pinch rollers minus
approximately 1 mm on each side
<Length>: 24,998 mm
<Width>: Distance between the two pinch rollers minus
approximately 1 mm on each side
<Length>: Detected length(*)
Cutting area
"Extending the