Table of Contents
Advertisement
Cutting Corners Cleanly
<Over Cut>
This function cuts an extra 1 mm at the start and end of each line. It is effective
when you want to produce particularly sharp corners, for example when cutting
thicker materials.
In most cases the over cut function should be set to [OFF]. Set it to [ON] when you
want to ensure that corners are cut cleanly. However, if the over cut function is
enabled when cutting small characters or complex shapes, areas of the material that
are required may be cut. In such cases it should therefore be set to [OFF].
OFF
Factory default setting OFF
Options
Procedure
Make sure the material is loaded in the machine.
Press [MENU] several times to display the
screen shown in the figure.
Press [ ] several times to display the screen
shown in the figure.
ON
OFF, ON
Hide quick links:
Advertisement
Table of Contents
