Table of Contents
Advertisement
Frequently Using Perforated
Cutting
There are two locations in which you can install the cutting carriage tool.
Normally install it in the rear position. Install it in the front position when cutting
perforated lines.
Installing the Cutting Tool
If you enable [BLADE DETECT] and send the cutting data, the tool's installation position will be
checked before cutting starts.
If the tool is installed in the incorrect position, operation will be paused and the following
message will be displayed to prompt you to install the tool in the correct position.
<When the cutting tool is installed in the front position and normal cutting is
being performed>
<When the cutting tool is installed in the rear position and perforated cutting is
being performed>
This function is useful for users who commonly switch between normal cutting and perforated
cutting. You can use this function to prevent products from being wasted due to the tool being
installed in the incorrect position.
When one of the messages shown above is displayed, install the cutting tool in the correct
position, and then press [PAUSE]. The pausing of machine operations is released, and the tool
position is detected again. Cutting starts if the tool installation position is correct.
Note that even if you disable [BLADE DETECT], when you send data that contains a mix
of normal cutting and perforated cutting, the second message shown above will be
displayed when normal cutting finishes.
Procedure
Make sure the material is loaded in the machine.
Press [MENU] several times to display the screen
* R = Rear
* F = Front
Hide quick links:
Advertisement
Table of Contents
