Table of Contents
Advertisement
Click OK.
The cutting data is sent to the machine. When the machine receives the data, it
automatically reads the crop marks using a sensor, and then starts cutting.
If the sensor fails to read the crop marks
If the sensor fails to read the crop marks, the screen in the figure appears. If this
screen appears, see
"Crop Marks Cannot be Read."
If this does not resolve the
issue, refer to
"Cutting in Tool Mode (1),"
and then perform positioning in tool
mode.
Remove the cut material.
Removing the Material
This completes the cutting procedure.
Hide quick links:
Advertisement
Table of Contents
