Table of Contents
Advertisement
The actual distance is longer than the W and L settings.
Set W and L in the Crop Mark Adjustment dialog box as
described below to correct the error.
However, the values are merely guidelines. The optimal values must be found by
changing the values and actually cutting the material several times.
CAUTION
Before changing the settings, check that the Base X and Base Y settings have been
adjusted with respect to a line or point close to the origin. If they were not, the
adjustment result of step 3 will be offset if the W and L settings are changed.
The Cutting Lines Are Offset Outward from the Printing Position
This may be because the distance between the printed crop marks is longer than the
setting. In this case, set the W and L values greater than the settings to make the
adjustment.
(1): Origin
(2): Cutting line
(3): Printing position
Hide quick links:
Advertisement
Table of Contents
