Setting Cutting Quality <QUALITY>
Is the blade force appropriate?
Carry out cutting tests and adjust the blade force until cutting can be performed
adequately.
Performing a Cutting Test
Is the amount of blade offset appropriate?
If the setting for the amount of blade offset is not correct for the blade, corners may
be rounded or have horns.
Setting the Amount of Offset for the Tip of the Blade <OFFSET>
Are the blade force and cutting speed appropriate?
Carry out cutting tests and adjust the settings until cutting can be performed
adequately.
Performing a Cutting Test
When using roll material, was the amount of material to be cut pulled
out before performing cutting?
If cutting is performed without pulling out the material, the material may slip or a
motor error may stop the operation
Loading Roll Material
Is the smoothing function turned off?