Installing A Consolidated Switch Fabric Card - Cisco 12404 Installation And Configuration Manual

Chapter 5 Maintaining the Cisco 12404 Internet Router
Step 7
Step 8
Step 9

Installing a Consolidated Switch Fabric Card

Step 1
Step 2
Step 3
Step 4
Caution
OL-11636-01
Touching only the metal card carrier, use your free hand to support the bottom of
the CSF.
Slide the card out of the slot and place it directly into an antistatic bag or other
ESD-preventive container.
If you plan to return the defective CSF to the factory, repackage it in the shipping
container you received with the replacement card.
To replace or install a CSF in the line card and CSF cage, refer to
follow these steps:
Attach an ESD-preventive strap to your wrist and to the chassis; or to a bare metal
surface.
Power down your router.
• Use the "Powering Off an AC Powered Router" section on page 5-3
powered routers.
Use the "Powering Off a DC Powered Router" section on page 5-5
•
powered routers.
After you have powered down your router re-attach an ESD-preventive strap to
your wrist or ankle; attach the ESD clip to the chassis or to a bare metal surface
and proceed to step 4.
Remove the CSF card from its antistatic bag or ESD-preventive container. Touch
only the metal card carrier
There are card slot alignment grooves on each side of the CSF cage. When
Note
you reinstall a card in an CSF slot, make sure you carefully align both
edges of the card carrier in the corresponding card slot grooves.
Avoid touching the card circuitry or any connectors.
Cisco 12404 Internet Router Installation and Configuration Guide
Removing and Replacing a Consolidated Switch Fabric Card
Figure 5-22 and
for AC
for DC
5-41