Powering On The Router - Cisco 12404 Installation And Configuration Manual

Chapter 3 Installing the Cisco 12404 Internet Router
Step 6
Step 7

Powering On the Router

Note
Checking the Startup
OL-11636-01
Secure each lead to the proper terminal port by tightening the terminal port
connector screws with a 3/16-inch flat-blade screw driver.
Verify that the DC power source circuit breaker servicing the DC PEM is
switched on.
Power on the router by switching on all the circuit breakers and/or plug the power
cord into an active power source that controls power to the router's AC PEM or
DC power distribution unit (PDU).
During the first-time startup, the system displays the system banner information.
Check the startup banner and displays to ensure that the system has restarted
properly and that all the interfaces reinitialize properly. You should observe the
power module LEDs shown in figures. Also, listen for the fans in the fan tray, you
should immediately hear them operating. In a noisy environment, the fans might
be difficult to hear; therefore, place your hand in front of the exhaust vents at the
side of the chassis to verify that the fans are operating.
Visually check the CSF LEDs
LEDs on the RP. RP LEDs are located at one end of the RP faceplate, near the
ejector lever. Figure 3-25
and Table 3-15 define the LEDs.
Cisco 12404 Internet Router Installation and Configuration Guide
Connecting a DC PDU and DC PEM Assembly
(Figure 3-23), MBus LEDs on the CSF, and the RP
shows the RP LED displays. Table 3-13, Table 3-14,
3-36