Cisco 12404 Installation And Configuration Manual page 111

Connecting to an AC Power Source
Figure 3-17
1
2
3
•
Locate the AC power cord and remove it from its shipping packaging. Verify that
Step 4
the AC power cord shipped with the power supply is the correct type for your site.
Note
Plug the AC power cord into the AC PEM.
Step 5
Connect the other end of the AC power cord to the AC power source outlet.
Step 6
Note
Cisco 12404 Internet Router Installation and Configuration Guide
3-29
AC PEM
1 2
6
AC PEM handle
On/Off switch
Bail Latch
All electrical connections between the power supply and the backplane are
made automatically when the power supply is fully inserted in the power
supply bay.
If you have an incorrect type of power cord, contact your service
representative for a replacement.
We recommend attaching each AC PEM to an independent power source
for full redundancy. We also recommend that you use an uninterruptable
power source (UPS) to protect against power failures at your site.
Chapter 3 Installing the Cisco 12404 Internet Router
3
IN PU T
O UT PU IN PU T
T
O UT PU
O K
T
O K 10 0- 24 0V
FA IL
12 A
50 /8 0H Z
5 4
4 Power cord receptacle
5 LEDs
6
Captive screws
OL-11636-01