Installing the Replacement Chassis
Reconnecting Power to the Router
Warning
Reconnecting Line Card Network Interface Cables
Reconnecting the Route Processor Cables
Reconnecting the Fan Tray
Cisco 12404 Internet Router Installation and Configuration Guide
5-52
Connect the AC power or DC power at the rear of the chassis as described in:
"Removing and Replacing an AC Power Entry Module" section on page 5-10
•
"Removing and Replacing a DC Power Entry Module" section on page 5-14
•
"Removing and Replacing a DC PDU" section on page 5-19
•
Do not turn on source power until instructed to do so.
Reconnect line card network interface cables as instructed in the
Line Card Network Interface Cables" section on page
Reconnect the cables to the RP as instructed in the
or Line Card" section on page
Reconnect the fan tray assembly as instructed in the procedure
Replacing the Fan Tray Assembly" section on page
Chapter 5
Maintaining the Cisco 12404 Internet Router
"Installing a Route Processor
5-34.
5-28.
"Reconnecting
5-52.
"Removing and
OL-11636-01