Cisco 12404 Installation And Configuration Manual page 92

Chapter 3 Installing the Cisco 12404 Internet Router
Figure 3-4
We strongly recommend that you connect the central office (CO) ground system
or interior equipment grounding system to the chassis. Grounding to the CO
system or your interior equipment grounding system meets the network
equipment building system (NEBS) bonding and grounding requirement.
To meet this requirement, crimp a dual-hole lug to #6 AWG cable and connect the
lug to the chassis using two 6.3 mm (M6) screws (see
The spacing between the holes on the lug is 0.63 inch (16 mm). A dual-hole lug
Note
meeting these specifications can be ordered directly from Cisco (Part Number
32-0607-01).
OL-11636-01
Supplemental Bonding and Grounding Port for NEBS
Compliance
CLAS S 1 LASE
CLE AN
R PROD UCT
CONNE CTOR LASER PROD
WITH ALCOHO UKT DER KLASS
WIPES L PROD UIT LASE E 1
CONNEC BEFORE R DE CLAS SE
TING
1
PROD UCTO LASER TX
DE CLASS E 1
0
1
RX
2
3
ACTIVE
CARRIE R
RX PKT
40C 48/ PO
GIG AB
IT RO UT
E PR OC
MBU S
ALAR M FABR
IC
FAIL
ENA BLE
CO NS OL
ID AT ED
SW IT CH
Cisco 12404 Internet Router Installation and Configuration Guide
Installing a Cisco 12404 Internet Router
S-S R-S C
ES SO R
FA BR IC
Figure 3-4).
3-10