Installing A Flash Memory Card - Cisco 12404 Installation And Configuration Manual

Chapter 3 Installing the Cisco 12404 Internet Router

Installing a Flash Memory Card

Note
OL-11636-01
By default, a Flash memory card containing a valid Cisco IOS software image is
inserted in bottom slot, PCMCIA slot 0 before the router is shipped.
PCMCIA slot 0 is the bottom slot and slot 1 is the top slot. Both Flash memory
card slots on each RP can be used at the same time.
The software configuration register is set to 0x0102, which causes the router to
boot automatically from the Cisco IOS software image stored on the Flash
memory card.
The Flash memory card that shipped with your system is installed in the
•
bottom slot, PCMCIA slot 0 of the RP. See
Figure 3-9 Flash Memory Card Slots
Ensure that a console terminal is connected to the RP console port and turned on,
or that you have a remote login to the router from another device through a telnet
session.
Cisco 12404 Internet Router Installation and Configuration Guide
Connecting to the Console Port and Auxiliary Ports
Figure 3-9.
3-20